Netgear wireless routers are among the best selling routers in the market. They support latest technology and all kind of devices. But sometimes you are watching something and abruptly there is not internet connection. First give it some time and wait for a few minutes to get the connection back automatically but if you still find Netgear router not working. You can go through the troubleshooting steps and resolve the issue. The issue can arise due to many reasons. The modem or the router may be overheated and it can stop working. There can be a service outage or internet connectivity issue from the server’s end. In that case, contact your internet service provider and enquire about the problem. Another reason because of which your Netgear router might stop working is the faulty Ethernet cable. It is also possible that the device itself is faulty or broken. Let’s have a look at some of the ways through which you can fix these errors.
Ways to resolve Netgear router not working:
- First of all, make sure that the router has been placed properly. Avoid setting it up at a place with too many electric appliances.
- Check the Ethernet cable and all the wires and cables attached to the router. The wires should not be twisted or corrupted. Plug them correctly.
- Try changing the channel on your router.
- Restart the router and perform the power cycle. Unplug the devices and wait for a few minutes to plug them back again.
- Check for latest updates and update the firmware of the router.
- Reset the router back to factory default settings.
You can also set the router to Netgear bridge mode and see if the router works. It will disable the NAT feature and enable the DCHP server without the IP address of the router. Another issue that users face is Netgear extender won’t connect to router. In that case, reboot the router and the extender. Then, reconnect to the Wi-Fi. Open a web browser in a device connected and re run the Netgear extender setup wizard.
If you want to connect any device to the router, you can establish a connection using the WPS method. Netgear router WPS button is located at the back of the router, near the Ethernet port. You can long press the button on the router and within two minutes, press the WPS button on the device. The two devices will recognize each other and establish a connection.
